Do you want to avoid common network cable installation mistakes?

The Internet is crucial in our everyday lives. Many businesses run on the Internet. They rely on having a strong network.

Don’t make the mistake of having an improper setup. The fastest setup doesn’t equal the best setup. There are many things to consider when setting up a network.

To learn what to avoid in network installs, read this informative guide. Let’s get started!

1. Poor Cable Management 

Poor cable management is one of the most common network cable installation mistakes. Ensure your cabling is properly managed, ensure all cables are labeled properly, and do not run them in any areas that could cause damage or create a trip hazard.

It’s also important to provide adequate spacing between cables and ensure your network cabinet is not overcrowded. Finally, it is important to keep the cables clean, dust-free, and well-organized to ensure that the cables last for a long time and that the installation is not hindered down the line.

You just need to make sure to look for a cabling contractor to help you out.

2. Running Cables Parallel to Electrical Cables

During the cable installation process, it is important to avoid running them parallel to any type of electrical cable. This will help prevent interference, which can drastically reduce the signal quality and performance of the network.

Additionally, running network cables parallel to any electrical cables can create a fire hazard by increasing the heat and possibly igniting any exposed wires. To prevent this, avoid running network cables parallel to any electrical cables. 

3. Separate Cables for Data and Voice 

When it comes to cable installation, one of the most common mistakes is the improper routing of data and voice cables. Cables used for voice communication, such as VoIP, should be separated from the data cables, such as Ethernet cables, as the signals tend to interfere.

When it comes to cables, data and voice cables should not be run in parallel to each other. It is advised to consider the cable layout beforehand to prevent any overlap or interference with other cables. 

4. Limited Space for Removal

Accidentally cutting network cables during installation can be costly and lead to service disruption. To avoid these errors, limited space for removal should be considered.

Homeowners and businesses should measure all necessary dimensions before the installation and consider moving or rewiring existing property to create adequate access. A technician should be consulted if the space is at risk of not providing clearance for safe removal. 

5. Not Completing Proper Testing

Not running proper tests after a network cable installation is a mistake that could cost a business both time and money. If a cable is not tested correctly, then faults may occur later, so it is important to double-check the work.

To avoid this mistake, it is best to test each cable using a network testing tool, typically a cable tester. This device should be used to test the integrity of each installed cable, ideally before the wall plates are put in place. 

Avoid These Network Cable Installation Mistakes Starting Today

To avoid common network cable installation mistakes, always plan, use the right tools and materials, and test the cables once installed. A bad installation can be costly, so double-check your work for accuracy and efficiency.

Contact a local data cabling professional for help, and never underestimate the power of proper network cable installation.

Did you find this article helpful? Check out the rest of our blogs!